All About Heating And Cooling Gazette Today

Common Reasons A Furnace Stops Working

Apr 8

Furnaces are reliable sources of heat for homes and commercial establishments. While they are made sturdy, they can still break down, and it can be quite a challenge to fix when they do. If you have no experience repairing heating systems, you may need to find a trusted company to fix your furnace in White Oak, TX.

It's important to be aware of the possible reasons your furnace stops working. Here are the most common reasons:

Filters Are Clogged

A furnace has filters that need to be changed every few months. Filters are the easiest thing to check. It does not require special tools. But if you have forgotten to replace them, the dirt buildup can cause the furnace to overheat because of the decrease in airflow.

Motor Needs Lubrication

If your furnace starts to make weird noises, it's possible that the bearing in the motor needs to be lubricated. When you hear noise in your furnace, turn it off immediately and avoid using it until it's fixed; otherwise, it can damage the components.

Faulty Furnace Ignitor

You can tell that there's something wrong with the furnace ignitor if it fails to ignite and activate the heat. The ignitor might be worn down, or there's an electrical issue. If you have an electric furnace, you should check if the hot surface ignitor is not glowing. If you have no electrical knowledge, just call for professional help to fix your furnace in White Oak, TX.

Interrupted Thermostat Settings

The thermostat is one of the first things to check if your furnace stops working. Is it turned on? Is it set in the correct heat setting? Maybe it needs a battery replacement. The problem could also be electrical, so it's best to rule out all possible causes.

Flipped Circuit Breaker

If your furnace is not getting any power, it could be a flipped circuit breaker problem. You can reset the tripped breaker and see if it restores the power to your furnace. If not, you will need an expert technician to fix your furnace in White Oak, TX.

Dirty Burners

If your heater is not warming up enough, the reason could be dirty burners. You can easily clean your burners by first turning off the electricity and the gas. Then remove the furnace panel and find the burners. Detach the burners and clean debris using a soft cloth or brush. Blow air to the area where the burner is attached to remove internal debris. Restore everything and see if it improves the heating performance.

How To Resolve Problems With Your Furnace In White Oak, TX

You can DIY specific furnace problems, such as cleaning burners and filters, replacing them, and checking the thermostat. However, if the problem is electrical or broken components, it's best to leave the solution in the hands of experts.

By hiring a professional to inspect and fix your malfunctioning furnace in White Oak, TX, you can have peace of mind knowing your equipment is in the right hands. But since HVAC contractors aren't the same, it is still best to look for a proven trustworthy company.

When choosing a company to service your furnace in White Oak, TX, it's best to choose one with a long history of furnaces and heating equipment expertise, such as Napps Cooling Heating Plumbing. The company has been in the HVAC industry for around 50 years. Their technicians are also all highly trained and certified. In addition to furnace repair, they also offer furnace installation and maintenance.

You can contact them any time, 24/7, to schedule an appointment.